Using The Cascade Connection Via Lan (Up To 10 Points) - Sony PCS-XG80 Operating Instructions Manual

Using the Cascade Connection via LAN (Up to 10 Points)

Installing the optional PCSA-MCG80 HD MCU software in two HD Visual
Communication Systems enables cascade connection with two main terminals,
allowing you to make a multipoint connection among up to ten points by
connecting four to each main terminal.
POWER/STANDBY
/
POWER/STANDBY
/
/
PCSA-MCG80 HD
MCU software
POWER/STANDBY
/
POWER/STANDBY
/
Notes
• Even if the PCSA-MCG80 HD MCU software is installed in three or more
Communication Systems, cascade connection is not available.
• For cascade connection, "Broadcast Mode" can be set to "Voice Activate" mode only
during communication. The "Split" and "Split (fixed)" modes are not available.
• Only the PCS-XG80/XG80S/XA80 is enabled for use as a main terminal on the
remote site.
POWER/STANDBY
Connection Examples of a Multipoint Connection
POWER/STANDBY
/
PCSA-MCG80 HD
MCU software
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
POWER/STANDBY
/
199