Adjusting The Brightness - Sony PCS-XG80 Operating Instructions Manual

4
Adjust the camera angle so that the desired angle of view is obtained with
the V, v, B or b button on the Remote Commander.
The selected camera pans and tilts, then the adjusted picture will be
displayed in the small window or in full screen.
Note
The PCS-XA80/XA55 does not support pan/tilt camera controls via the Remote
Commander.
5
Use the ZOOM button on the Remote Commander to zoom in or out.
Press the T (Telephoto) button to zoom in and the W (Wide angle) button
to zoom out.
For details on digital zoom, see "To use the digital zoom function" on page
152.
To control the remote camera
• To control the remote camera, set "Far End Camera Control" (page 75) to
"On" in the Communication setup menu for both the local and remote sites.
If this setting is not configured properly, you will not be able to control the
remote camera.
• You cannot control the remote camera during a session if the remote control
format of the remote camera is not H.281. If you cannot control the remote
camera, ask the remote party about the remote control format of his camera.
• If the local and remote parties try to control the same camera at the same
time, the camera may not operate correctly.

Adjusting the Brightness

Normally, the brightness is automatically adjusted to obtain optimum levels.
You can also adjust it manually.
It is recommended that the brightness be adjusted automatically to obtain
optimum brightness.
Adjustments > Camera Angle
Local Camera : First Camera
T
W
Pan/tilt indicator
Zoom indicator
Adjusting the Camera
147