Sony PCS-XG80 Operating Instructions Manual page 99

Disabled: Prohibits access via a Web
browser.
Telnet Access
Select whether to permit access to the
Communication System via Telnet.
Enabled: Permits access via Telnet.
Disabled: Prohibits access via Telnet.
SSH Access
Allows you to select whether to permit
access to the Communication System via
SSH (Secure Shell).
Enabled: Permits access via SSH.
Disabled: Prohibits acces via SSH
Image Flip for First Camera
Allows you to select whether to rotate the
camera image 180 degrees when the first
camera is installed on a ceiling.
Flip Vertical: Rotates the image 180
degrees.
Off: Does not rotate the image 180 degrees.
Image Flip for Second Camera
Allows you to select whether to rotate the
camera image 180 degrees when the second
camera is installed on a ceiling.
Flip Vertical: Rotates the image 180
degrees.
Off: Does not rotate the image 180 degrees.
Notes
• The "Image Flip" function will be enabled
after system rebooting.
• The "Image Flip" function cannot be used
with the PCSA-CXG80/CXA55 HD Camera
Unit.
• The PCS-XA80/XA55 does not support the
use of a second camera.
Administrator7
Other
Use History
Select whether to display the history lists in
order to use for dialing, etc.
On: Displays the history lists.
Off: Does not display the history lists.
Save Setup
Saves the data for each setting to a "Memory
Stick". The data for each setting saved on the
"Memory Stick" is overwritten.
Note
Phone Book and History data are not saved.
Load Setup
Loads the data for each setting from a
"Memory Stick". The data for each setting
saved on the System is overwritten.
Note
When saving and loading settings, make sure
that the version of the system from which the
data was originally saved is the same as the
version of the local system. If the versions
differ, the data may not be properly recognized.
AMX Device Discovery
Select whether to export AMX Device
Discovery information onto the network.
Off: Disables this function.
On: Enables this function.
When the AMX system is connected to the
Communication System via serial
connection, AMX Device Discovery
information is output via that serial
connection.
AMX systems are external control devices
that can be used to control the
Communication System. When the AMX
system receives Device Discovery
information from the Communication
System, the System automatically falls
under the control of the AMX system.
HOP
Enter a number from 0 to 255 as the HOP
Display Terminal Name.
1080 Mode (PCS-XG80/XG80S only)
Allows you to select whether to transmit or
receive the picture in 1080i/p video format.
Transmission and reception of the picture in
1080i/p video format is available only for
connection via LAN.
You can connect to a remote party in 1080
mode only via one-touch dial.
Off: Does not use 1080i/p video format.
On: Uses 1080i/p video format. When set to
"On", the system reboots automatically.
Registering Local Information
99