Sony PCS-XG80 Operating Instructions Manual page 186

Video Input > Near
CAMERA
Use the V, v, B or b button on the Remote Commander to select the external
equipment connected to each video input on the Communication System, then
press the ENTER buttton.
The picture from the selected equipment is displayed.
CAMERA: Video shot by the camera unit connected to the CAMERA
connector.
S VIDEO: Video of the camera or video equipment connected to the S VIDEO
IN connector.
RGB: Video of a computer, etc. connected to the RGB IN connector.
YPbPr: Video of the camera or video equipment connected to the VIDEO IN
YPbPr jacks.
Note
S-VIDEO
The "
To save the selected input, press the V, v, B or b button on the Remote
Commander to select "Save", then press the ENTER button.
To input audio
Set "Audio Input" to "AUX" or "MIC+AUX" on the Basic Setup1 page of the
Audio setup menu (page 77).
When set to "AUX", the sound from the external equipment is input and the
sound from a microphone is deactivated. When set to "MIC+AUX", both
sounds are input.
To switch to the sound from the external equipment connected to the AUDIO
1 IN or AUDIO 2 IN jacks, set "Input Select (AUX)" to "AUDIO1" or
"AUDIO2" on the Basic Setup1 page of the Audio setup menu (page 77).
Note
The AUDIO 1 IN jack is not available on the PCS-XG55/XG55S/XA55, and the
AUDIO 2 IN jack is labeled AUDIO IN.
To switch the input video and audio at the same time
Set "Link to Audio Input" to "On" on the Link to Mic page of the Video setup
menu (page 82) so as to link the audio you want to switch at the same time with
the video input.
When the video input is switched, the audio input is simultaneously switched
to the one linked to the video input.
186
Sending Audio/Video from the External Equipment to a Remote Party
S VIDEO
" setting is not available on the PCS-XG55/XG55S/XA55.
RGB YPbPr
Save Cancel