Sony PCS-XG80 Operating Instructions Manual page 85

100Mbps Full Duplex: Connects via
100BASE-TX in full duplex mode.
100Mbps Half Duplex: Connects via
100BASE-TX in half duplex mode.
10Mbps Full Duplex: Connects via
10BASE-T in full duplex mode.
10Mbps Half Duplex: Connects via
10BASE-T in half duplex mode.
LAN
PPPoE
PPPoE
Allows you to select whether to use PPPoE
for LAN connection.
When using PPPoE, you can use the B
FLET'S* or FLET'S ADSL service without
connecting a router.
Off: Does not use PPPoE.
LAN1: Uses PPPoE for LAN connection
using the 1 (LAN1) connector (
(LAN) connector on the PCS-XG55/
XG55S).
LAN2: Uses PPPoE for LAN connection
using the 2 (LAN2) connector.
Notes
• The "LAN1" setting is called the "On"
setting on the PCS-XG55/XG55S/XA55.
• The "LAN2" setting is not available on the
PCS-XG55/XG55S.
• Operations of PPPoE for LAN connection
are presently verified only for the Japanese
NTT B FLET'S and FLET'S ADSL services.
• The PPPoE registration status appears at the
bottom of the screen for each page.
* "FLET'S" is a trademark of NTT East and
NTT West Corporations in Japan.
User Alias
Enter a user name when you use PPPoE for
LAN connection.
Password
Enter a password when you use PPPoE for
LAN connection.
Fixed IP for PPPoE
Select whether to make a PPPoE connection
using a fixed IP address.
Off: Does not use a fixed IP address for a
PPPoE connection.
On: Uses a fixed IP address for a PPPoE
connection.
Fixed IP Address for PPPoE
Enter an IP address when "Fixed IP for
PPPoE" is set to "On".
DNS
Allows you to select whether to obtain DNS
server addresses automatically or to specify
them manually when connecting to a LAN
using PPPoE.
Obtain automatically: Assigns DNS server
addresses automatically.
Specify: Allows you to specify DNS server
addresses.
Primary DNS
Enter a primary DNS address.
Secondary DNS
Enter a secondary DNS address.
LAN
NAT Setup
NAT Mode
Allows you to select whether you connect
the system to a local network using Network
Address Translation (NAT), which allows
one IP address to be shared by several
computers on the same LAN.
Auto: Enables or disables the NAT mode by
automatically detecting the use of NAT.
This option is effective only when you
use the UPnP router.
On: Enables NAT mode.
Off: Disables NAT mode.
WAN IP Address
Enter the IP address for the Wide Area
Network (WAN).
LAN
Gatekeeper
Note
When "Internet Protocol" is set to "IPv4/IPv6"
in the Administrator setup menu, configure the
settings in the "Gatekeeper: IPv6" screen.
Registering Local Information
85