Using The Cascade Connection Via Lan (Up To 10 Points) - Sony IPELA PCS-G70 Operating Instructions Manual

Using the Cascade Connection via LAN (Up to 10 Points)

Installing the optional PCSA-M3G70 H.323MCU software in two
Communication Terminals enables cascade connection, allowing you to
conduct a multipoint videoconference with up to ten points.
PCSA-
M3G70
H.323 MCU
software
TERMINAL VISCA OUT
MCU VIDEO OUT AUDIO OUT AUDIO IN
(MIXED) AUX LINE MIC
(PLUG IN POWER)
1
1 2 3 4 5
DC 19.5V IR OUT 1 2
EC-MIC
AUX CONTROL
1 2 CTRL-S 1 2
AUX MONITOR
VIDEO OUT
to 100BASE-TX/
10BASE-T
Notes
• Installing the PCSA-M3G70 H.323 MCU software into three or more
Communication Terminals does not allow cascade connection. Note that the third or
later terminals should set "Multipoint Mode" to "Auto" on page 4 of the
Communication Setup menu.
• For cascade connection, the "Split" and "Split (Fixed)" modes are not available. Only
the "Voice Activate" mode is available.
• The remote parties must be using PCS-1/1P, PCS-G50/G50P, or PCS-G70/G70P
Video Communication Systems.
to LAN
MAIN SUB
CAMERA AUX IN CAMERA AUX IN
2
WHITE 100BASE-TX/
RGB OUT BOARD 10BASE-T DSB
ISDN UNIT
UTP cable (category 5,
straight) (not supplied)
Connection Examples for a Multipoint Videoconference
PCSA-M3G70 H.323
MCU software
POWER
POWER
POWER
POWER
POWER
LAN
POWER
POWER
POWER
POWER
LAN
205