Cateye Strada Smart CC-RD500B Online Manual page 7

Tap [Pair] to complete pairing.
After pairing is completed, from
switch to the Trip screen.
When pairing is complete, Strada Smart switches from the smartphone search screen to
the [ready] (measurement standby) display.
Strada Smart pairing is now complete.
* If you have other sensors, continue pairing them.
Strada Smart can be used with sensors compatible with Bluetooth 4.0. Pair it with optional
accessories or commercial sensors as required.
• Pair all sensors that you intend to use. If you want to pair another sensor, repeat the
same procedure again.
• Using an iPhone with a commercial sensor
When measuring in Sensor Direct Mode, after configuring the smartphone, it is
necessary to pair the sensor with Strada Smart and re-configure tire circumference via
the procedure below.
1. Switching to Sensor Direct Mode
2. Pairing (Sensor ID synchronization)
3. Tire circumference setting
1. Activate the sensor.
Activating the sensor
When Cateye Cycling™ detects the sensor signal, a message is displayed on the
smartphone.
Tap [Pair]. The synchronized sensor is displayed on the [Device] screen and pairing is
completed.
* If you have paired a sensor capable of speed measurement, proceed to step 2.
2. Enter the tire circumference.
From the [Device] screen, tap the added sensor and select a tire circumference (the
length of the outer circumference of the tire).
* Default value: 2,096 mm (700x23c)
* Set tire circumference for each sensor.
(MENU) at the top left of the screen, tap [Trip] to
Strada Smart
Smartphone
search
screen
Pairing with a sensor
Important
Smartphone
Measurement
standby