Cateye Strada Smart CC-RD500B Online Manual page 27

* If Strada Smart switches to the measurement screen without the whole screen turning
on, it has not been formatted. Redo the procedure.
2. Display the desired measurement unit.
Press MENU to proceed to the next step.
3. Pair a sensor.
Strada Smart can be used with sensors compatible with Bluetooth 4.0. Pair it with optional
accessories or commercial sensors as required.
• Pairing (ID synchronization) must be performed in order to use a sensor.
• Avoid pairing sensors at a race venue or in similar locations where there are
many other users. Doing so may cause Strada Smart to be paired with another device.
• Pair all sensors that you intend to use.
Activate the sensor that you want to pair.
Activating the sensor
The synchronized sensor is displayed on the top of the screen and pairing is completed.
* To pair another sensor, press MODE for 2 seconds to return to the synchronization
standby screen, and repeat the same procedure.
*If pairing is not successful and you cannot proceed to the next step, press MENU to skip
pairing. After setup is complete, retry pairing again from the menu screen.
Press MENU to proceed to the next step.
Important
Ready for Sensor
synchronization activated
Synchronization
complete