Cateye Strada Smart CC-RD500B Online Manual page 128

Pair a sensor that you want to use with Strada Smart.
• Pairing (sensor ID synchronization) must be performed in order to use a sensor.
• Do not pair sensors at a race venue or in similar locations where there are many other
users. Doing so may cause Strada Smart to be paired with another sensor.
• Pair all sensors that you intend to use.
1. From the measurement screen, press MENU to switch to the menu
screen.
* When the menu screen is left on for 1 minute, Strada Smart returns to the measurement
screen.
2. Press MODE to display the screen shown below, and then press MODE
for 2 seconds.
3. Activate the sensor that you want to pair.
Activating the sensor
The synchronized sensor is displayed on the top of the screen and pairing is completed.
When Strada Smart displays [FULL] on the screen and returns to the menu:
Up to 9 separate sensor IDs can be paired with Strada Smart. If the maximum number of
sensors have been paired, with the computer in pairing standby state, press MENU for 4
seconds to clear all pairings.
Pairing (Sensor ID synchronization)
Important
Measurement
screen
Ready for Sensor
synchronization activated
Menu screen
(Clock setting)
(2 seconds)
Synchronization
complete
Important