ZyXEL Communications ZyAIR User Manual page 245

FIELD
Destination IP This parameter specifies the IP network address of the final destination. Routing is
Address always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number to
be identical to the host ID.
IP Subnet Type the subnet mask for this destination. Follow the discussion on IP Subnet Mask in
Mask this manual.
Gateway IP Type the IP address of the gateway. The gateway is an immediate neighbor of your
Address ZyAIR that will forward the packet to the destination. On the LAN, the gateway must be a
router on the same segment as your ZyAIR; over WAN, the gateway must be the IP
address of one of the remote nodes.
Metric Metric represents the "cost" of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected networks.
Type a number that approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good number.
Private This parameter determines if the ZyAIR will include the route to this remote node in its
RIP broadcasts. If set to Yes, this route is kept private and is not included in RIP
broadcasts. If No, the route to this remote node will be propagated to other hosts
through RIP broadcasts.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
Remote Node Configuration
Table 21-3 Menu 12.1 Edit IP Static Route
ZyAIR Wireless Gateway Series User's Guide
DESCRIPTION
21-9