ZyXEL Communications ZyAIR User Manual page 227

ZyAIR Wireless Gateway Series User's Guide
FIELD
Select Disable to allow wireless stations to communicate with the access
WEP
points without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Default Key Enter the key number (1 to 4) in this field. Only one key can be enabled at
any one time. This key must be the same on the ZyAIR and the wireless
stations to communicate.
Key 1 to The WEP keys are used to encrypt data. Both the ZyAIR and the wireless
Key 4 stations must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5
ASCII characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13
ASCII characters or 26 hexadecimal characters ("0-9", "A-F").
key. Don't enter "0x" before the key to denote a ASCII
Authen. Press [SPACE BAR] to select Auto, Open System Only or Shared Key
Only and press [ENTER].
Method
This field is N/A if WEP is not activated.
If WEP encryption is activated, the default setting is Auto.
Block Intra- Press [SPACE BAR] to select Yes or No and press [ENTER].
BSS Traffic
Number of Enter the maximum number of wireless stations that may connect to the
Associated ZyAIR. The number should be from 1 to 32.
Stations
Breathing Press [SPACE BAR] to select Yes or No and press [ENTER].
LED
Press [SPACE BAR] to select 11dBm, 13dBm, 15dBm or 17dBm and
Output
Power press [ENTER].
19-8
Table 19-4 Menu 3.5 Wireless LAN Setup
Enter "0x" before the key to denote a hexadecimal
DESCRIPTION
key.
EXMAPLE
Disable
1
0x12345abcde
Auto
No
Yes
17dBm
LAN Setup