Figure 24-7 Menu 21.1.1 Tcp/Ip Filter Rule; Table 24-3 Menu 21.1.1 Tcp/Ip Filter Rule - ZyXEL Communications ZyAIR User Manual

The following table describes how to configure your TCP/IP filter rule.
FIELD
Filter #
Filter Type
Active
IP Protocol
IP Source Route
Destination:
Filter and Firewall Configuration
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Drop
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:

Figure 24-7 Menu 21.1.1 TCP/IP Filter Rule

Table 24-3 Menu 21.1.1 TCP/IP Filter Rule

This is the filter set, filter rule coordinates, for instance, 2, 3
refers to the second filter set and the third filter rule of that
set.
Press [SPACE BAR] and the [ENTER] to select filter type.
Choices are TCP/IP Filter Rule or Generic Filter Rule.
Select Yes to activate or No to deactivate the filter rule.
This is the upper layer protocol, for example, TCP is 6, UDP
is 17 and ICMP is 1. The value must be between 0 and 255.
A value of 0 matches ANY protocol.
IP Source Route is an optional header that dictates the route
an IP packet takes from its source to its destination. If Yes,
the rule applies to any packet with an IP source route. The
majority of IP packets do not have source route.
ZyAIR Wireless Gateway Series User's Guide
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #=
Port # Comp= None
Log= None
DESCRIPTION EXAMPLE
1,1
TCP/IP Filter
Rule
No
0 to 255
No
(default)
24-7