Restoring The Factory Default Settings; Encrypting The Printer Hard Disk - Lexmark C935 Series User Manual

Administrative support
4
Press repeatedly until
5
Press repeatedly until
6
Press repeatedly to decrease or
Saver mode, and then press
Note: Power Saver settings can also be adjusted by issuing a Printer Job Language (PJL) command. For more
information, see the Technical Reference available on the Lexmark Web site at www.lexmark.com/publications.

Restoring the factory default settings

1
From the control panel, press
2
Press until Settings appears, and then press
3
Press until Setup appears, and then press
4
Press until Factory Defaults appears, and then press
5
Press until Restore Now appears, and then press
Restoring Factory Defaults appears.
Warning—Potential Damage: Restore Now returns all printer settings to the factory default settings except
Network/Port menu settings. All downloads stored in RAM are deleted. Downloads stored in flash memory or
on a printer hard disk are not affected.

Encrypting the printer hard disk

This functionality is available only when a printer hard disk is installed and working properly.
Warning—Potential Damage: All files and resources on the printer hard disk will be deleted. Resources residing in
the printer flash memory or RAM will not be affected.
1
Turn the printer off.
2
From the control panel, press and hold
3
Release both buttons when Performing Self Test appears.
The printer performs its power‑on sequence, and then CONFIG MENU appears.
4
Press repeatedly until
5
Press repeatedly until
Note: Select Enable to enable hard disk encryption or Disable to disable hard disk encryption.
Contents will be lost. Continue? appears.
Setup Menu appears, and then press
Power Saver appears, and then press
repeatedly to increase the number of minutes before the printer enters Power
. Available settings range from 2–240 minutes.
.
and while turning the printer on.
Disk Encryption appears, and then press
appears next to Enable or Disable, and then press
.
.
.
.
.
.
.
.
150