Lexmark C935 Series User Manual page 85

Understanding printer menus
Menu item
Standby Mode
Disabled
1–240
Alarms
Alarm Control
Toner Alarm
Staple Alarm
Hole Punch Alarm
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Timeouts
Wait Timeout
Disabled
15–65535
Description
Sets the amount of time in minutes the printer waits—in a
ready‑to‑print state, after a job is printed—before passing into
Power Saver mode
Notes:
•
Disabled is the factory default setting.
• This setting must be less than or equal to the Power Saver
mode setting.
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
•
Off is the factory default setting for Toner Alarm, Staple
Alarm, and Hole Punch Alarm. Off means no alarm will
sound.
• Continuous repeats three beeps every 10 seconds.
• Stapler Alarm and Hole Punch Alarm are available only when
the finisher is installed.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print job
Notes:
• 90 seconds is the factory default setting.
• When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
•
Print Timeout is available only when using PCL or PPDS
emulation. This setting has no effect on PostScript emulation
print jobs.
Sets the amount of time in seconds the printer waits for additional
data before canceling a print job
Notes:
•
40 seconds is the factory default setting.
•
Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL or
PPDS emulation print jobs.
85