Understanding printer menus
Menu item
Portrait Width
3–48 inches
76–1219 mm
Portrait Height
3–48 inches
76–1219 mm
Feed Direction
Short Edge
Long Edge
Bin Setup menu
Menu Item
Output Bin
Standard Bin
Bin 1
Bin 2
Description
Sets the portrait width
Notes:
•
If the width exceeds the maximum, the printer uses the maximum
width allowed.
•
12 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
•
305 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Sets the portrait height
Notes:
•
If the height exceeds the maximum, the printer uses the maximum
height allowed.
•
19 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
•
483 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Specifies the feed direction
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
maximum length supported in the tray.
Description
Identifies installed output bins
Note: Standard Bin is the factory default setting.
81