Installing A Memory Card; Installing A Flash Memory Or Firmware Card - Lexmark C920 User Manual

Installing a memory card

Complete the following instructions to install a printer memory card.
Note: Memory cards designed for other Lexmark printers may not work with your printer.
1
Remove the system board access cover. (See Removing the system board access cover.)
2
Push open the latches on both ends of the memory card connector.
3
Unpack the memory card.
Warning: Printer memory cards are easily damaged by static electricity. Touch something metal such as the
printer frame before you touch a memory card.
Avoid touching the connection points along the edge of the card. Save the packaging.
4
Align the notches on the bottom of the card with the notches on the connector.
5
Push the memory card firmly into the connector until the latches on either end of the connector snap into place.
It may require some force to fully seat the card.
6
Make sure each latch fits over the notch on the end of the card.

Installing a flash memory or firmware card

Note: Flash memory and firmware cards designed for other Lexmark printers may not work with your printer.
1
Remove the system board access cover (see Removing the system board access cover).
Warning: Flash memory and firmware cards are easily damaged by static electricity. Touch something metal,
such as the printer frame, before you touch a card.
2
Unpack the flash memory or firmware card.
Avoid touching the metal pins on the bottom of the card. Save the packaging.
Installing and removing options
Notches
Installing a memory card
29