Troubleshooting
Using the printer troubleshooting software (Windows
only)
The Lexmark Service Center provides step-by-step troubleshooting help and contains links to printer maintenance
tasks and customer support.
To open the Lexmark Service Center, use one of these methods:
Method 1
If it appears on an error message dialog, click the For
additional assistance, use the Lexmark Service
Center link.
Setup troubleshooting
Incorrect language appears on the display
These are possible solutions. Try one of the following:
C
HANGE THE LANGUAGE SELECTION DURING INITIAL SETUP
During initial setup, and every time you reset the printer to factory default settings, you will be asked to select a
language.
To select a language, press the arrow buttons until the language that you want appears on the display, and then
press
.
S
ELECT A DIFFERENT LANGUAGE AFTER INITIAL SETUP
In case the wrong language was set during initial setup, you can still change the language settings of the printer.
1
From the printer control panel, press
2
Press
, and then press
3
Press
again.
4
Press the arrow buttons until the language that you want appears on the display, and then press
5
If you are sure, press
.
.
to change the language.
Method 2
1
Do one of the following:
•
In Windows Vista, click
•
In Windows XP and earlier, click Start.
2
Click All Programs or Programs, and then select the
printer program folder from the list.
3
Select Lexmark Service Center.
104
.
.