Disable / Re-Enable Alert Annunciation Function (B11) - Panasonic EBL128 User Manual

Panasonic Eco Solutions Nordic AB
MEW01624 Rev: -
5.11 Disable / re-enable alert annunciation
function (B11)
Not available for users with access level / type "Information only".
Normal operation:
For alarm points / zones programmed for Alert Annunciation (via
EBLWin) is normally the AA function enabled via a time channel, e.g.
enabled daytime (during working hours) and disabled night time.
As an alternative, the AA function can be continuously enabled.
Turned Off
Via this menu (B11) it is possible to disable the AA function, i.e. the
AA function will be disabled for the alarm points / zones programmed
for Alert Annunciation in spite of the time channel is "on" or if they
are programmed to be continuously enabled.
The AA function will stay disabled until re-enabled again via this
menu.
NOTE! Disabled Alert Annunciation function is indicated by LED
"Fault / Disablements Fire brigade tx delay" (L16) turned off.

Log in with a User name and Password for typ Building officer (or
Service personnel), see page 5.
H1 Perform monthly test
Scroll (or press "2") to menu H2.
H2 Disable or re-enable

Press "A" to sub menu B1.
B1 Disable zone

Scroll to menu B11.
B11 Disable / re-enable alert annunciation function

Press "A".
Alert annunciation function is in normal operation
or
Alert annunciation function turned off
will be shown.

Press "A". The status changes.

Press "Return" (P9) to menu B11.

Scroll to another menu or press "Return" to menu H2. Scroll to
another menu or leave the menu system by pressing "Return".
EBL128 version 2.0.x, Daily user's manual
20