Panasonic FP-7818 Service Manual & Parts Manual page 140

Location
2
3
4
Toner bottle
TDC
Hopper
connector
Waste toner
bottle door
Release lever
Recycle solenoid
cover
Shipping material/Procedure
Paper transport unit
(1) Open the front cover.
(2) Remove the shipping tape.
(2)
Tape
Fuser unit
(1) Open the paper exit door.
(2) Open the fuser exit guide plate.
(3) Remove the fuser pressure
release screws. (2 screws)
(4) Close the fuser exit guide plate.
(5) Close the paper exit door.
Developer unit
(1) Swing open the toner bottle/
hopper. (180 degrees)
(2) Turn the developer unit release
lever clockwise.
(3) Remove the recycle solenoid
cover. (1 screw)
(4) Open the waste toner bottle door.
(5) Lower the paper transport.
(6) Remove the drum unit. (1 screw,
1 connector)
(7) Disconnect the TDC connector.
(8) Remove the developer unit.
(Pull out until it stops, then angle
up to remove.)
Note: B e c a r e f u l t o a v o i d
damaging the recycle and
toner addition sponge seals.
Check
6-3