Porsche 2012 911 GT3 CUP Technical Manual page 77

5.10.7. Setting the crown wheel & pinion
1. Position and fasten pre-mounted clamp plate (selector barrel with
SW1, driveshaft) to the gearbox housing.
2. Fit the oil pump drive gear and H4 washer
st nd rd th
3. Fit the gear ratio pairs 1 /2 and 3 /4 including shift rod
4. Position the needle roller bearing and the SW2 washer, as previously
removed (when not damaged), to the selector barrel.
5. Determine the depth of the cut-away housing used
6. Position and fasten the cut-away housing to the gearbox housing
7. Position the H5 washer to the driveshaft
8. Slide the mounting sleeve special tool 996.450.327.90 onto the
driveshaft and fix to the driveshaft with the nut (M30x1.25, 330 Nm).
74