Porsche 2012 911 GT3 CUP Technical Manual page 25

FLASHER
HIGH
BEAM
SPEED
3.6.3. Full throttle adjustment
a.) In Modas on the 'Throttle' page (in Engine F1) activate
the button 'Set Throttle'
b.) Switch to Warmup mode, press and hold the 'Display' and
'Alarm' buttons for approx. 3 seconds till the 'Reset' appears
in the display and THR_BO goes to 0°
WIPER
DISPLAY
ALARM
6. Screw the idle adjustment screw 1.) into the threaded
bush 3.) till a throttle value of appr. 6.5° (THR_BO in
Dash, wdkba_w in Modas) is displayed
7. The throttle value must NOT exceed 9° at idle (THR_BO
in Dash, wdkba_w in Modas)
8. Lock adjustment screw 1.)
9. Reconnect throttle cable to cam-disc
10. Tension the throttle cable (see 3.6.1.23.6.1)
Adjust the throttle pedal stop-screw so that full throttle equals 80° +/- 2°
(THR_BO in Dash, wdkba_w in Modas)
Attention: Only the adjustment screw under the throttle pedal
should be used to set full throttle. It is essential at full throttle, i.e.
when the throttle pedal is touching the stop, that there is sufficient
play in the throttle cable on the engine and that the throttle cable
movement is limited by the adjuster screw and NOT by the cable.
If the full throttle value is too high it is possible that mechanical
damage or a sticking throttle can occur.
throttle angle wdkba_w shows 0°

22