Table of Contents
Advertisement
When connecting with IEEE 1394
• The printer must be connected to the IEEE 1394 connector of a computer using the IEEE 1394
interface cable.
• [Activate] is selected in the SCSI print of IEEE 1394 and [Activate] is selected in the Bidi-SCSI
print.
• Under Windows 2000, [Enable bidirectional support] must be selected and [Enable printer pool-
ing] must not be selected on the [port] tab with RPCS printer driver.
When connecting with USB
The printer must be connected to the USB connector of a computer using the USB interface cable.
- Inactivating the Device
-
-
-
If you do not want to install the printer when [Found New Hardware Wizard] starts with an op-
erating system, which supports SCSI print, inactivate the device by following the procedures.
• Windows 2000
A
In [Found New Hardware Wizard] dialog box, and then click [Next>].
B
When the [This wizard will complete the installation for this Device: Unknown] message ap-
pears, and select [Search for a suitable driver for my device [recommended]], and then click
[Next>].
C
When the [Locate Driver Files] message appears, remove all the selections from [Optional
search locations.], and then click [Next>].
D
When the [Driver Files Search Results] message appears, select the [Disable the device. The
Add/Remove Hardware Wizard in the control Panel can be able to complete the driver installa-
tions.] check box, and then click [Finish].
Operating Instructions
Client Reference
82
Advertisement
Table of Contents
