Table of Contents
Advertisement
E
Configure the TCP/IP protocols with the appropriate IP address, subnet mask and other settings.
Confirm that the settings are correct with the network administrator.
Configuring NetBEUI for Printing
Follow these instructions to configure Network Interface Board and Windows 2000 to use the NetBEUI
protocol.
Preparation
To use NetBEUI, use the SmartNetMonitor for Client port.
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is active.)
Reference
For more information about how to make the above settings, see "Configuring the printer for the
Network" in the Quick Installation Guide.
Configuring a Windows 2000 computer
Follow these steps to configure a Windows 2000 computer to use the NetBEUI protocol.
A
Click [Start] on the taskbar, point to [Settings], and then click [Network and Dial-up Connections].
B
Click [Local Area Connection].
C
On the [File] menu, click [Properties].
D
Confirm that "NetBEUI Protocol" is selected in the [Components checked are used by this con-
nection:] box on the [General] tab.
Operating Instructions
Client Reference
58
Advertisement
Table of Contents
