Table of Contents
Advertisement
When using the PostScript 3 printer driver
Follow these steps to set up for the PostScript 3 printer driver.
A Click the [PostScript] tab.
B Click [Advanced].
C Click to clear the [Send CTRL+D before job] and [Send CTRL+D after job] check boxes.
L L L L
Click [OK] to close the Printer Properties.
- If a message is displayed during installation of the printer driver
-
-
-
When there is a driver in the computer that is newer than the one currently being installed, a message
dialog box appears.
In such a case, you cannot install with the Auto Run program. Use the driver that was used in installing
the driver that is displayed in the message, and reinstall with [Add Printer].
A
Click [Start], point to [Settings], and then click [Printers].
B
Double-click the [Add Printer] icon.
C
Follow the wizard to install the driver.
If the printer driver disk is a CD-ROM, the sources of installation are as follows. If the installer starts
up, click [Cancel] to quit it.
• PCL 5c
DRIVERS\PCL5C\WIN9X_ME\(Language)\DISK1
• RPCS
DRIVERS\RPCS\WIN9X_ME\(Language)\DISK1
• PostScript 3
DRIVERS\PS\WIN9X_ME\(Language)\DISK1
Operating Instructions
Client Reference
159
Advertisement
Table of Contents
