Lanier 5222 Operator's Manual page 20

Configuring the Printer for the Network
2 - 2
5
Select the protocol you want to use. You can select one of the items on the following table.
Menu item on the
panel display
All Active
(Default Setting)
None
TCP/IP Only
NetWare Only
TCP/IP & NetW
ATalk Only
TCP/IP & ATalk
NetWare & ATalk
TCP & ATK &
NW
NetBEUI only
TCP/IP & NB
NetBEUI & NetW
TCP & NB & NW
NetBEUI & ATalk
TCP & NB & ATK X
NB & NW &
ATalk
Note: <IconSt1>' means that this protocol is active.
Blank cell means that this protocol is not active.
You should not select protocols that are not used on your network.
If you want to select AppleTalk, you should install the optional PostScript kit
Type 185.
1. Press
the Up or Down Arrow keys
the following message appears.
2. Press [Enter #] .
The current settings appear on the
panel display.
3. Press
the Up or Down Arrow keys
the protocol you want to use appears.
4. Press [Enter #] .
The actual procedure may differ depending on the protocol you use. If you use
Active Protocol
TCP/IP NetWare
X X
X
X
X X
X
X
X X
X
X
X X
X
until
until
AppleTalk NetBEUI
X X
X
X
X
X
X
X
X
X
X X
X X
X X
Printer Configuration