Lanier 5222 Operator's Manual page 70

Error and Status Messages
Printer Configuration
You can check the printer configuration using the "mshell".
mshell
Use info command.
6 - 8
Messages Description
Remove Paper The standard output tray is full. Remove paper from the
Standard Tray
Remove Paper The PT270 (1bin tray) is full.
1Bin Tray
Reset Duplex Unit AD370 (duplex unit) is not set
Correctly correctly.
Reset Fusing Unit There is no fusing unit, or the
Correctly fusing unit is not installed
properly.
Reset PCU There is no Photo Conductor
Correctly Unit Type 270, or Photo
Conductor Unit Type 270 is
not installed properly.
Reset Tray XX There is no paper tray, or Tray
Correctly XX is not set correctly.
This message appears only for
the default tray. See "Job
Control Parameters" on page 7-
7.
Warming Up... The printer is now preparing for
printing.
Item
Input Tray
No.
Name
Page Size
Status
Description
ID number of the paper tray
Name of the paper tray
Paper size loaded in the paper tray
Current status of the paper tray
Resolution
standard output tray
Remove paper from the output
tray before it becomes full. If
you leave paper in the output
tray, it can cause a paper
misfeed.
Remove the paper from the
PT270 (1bin tray).
Remove the paper from the
output tray before it becomes
full. If you leave paper in the
output tray, it can cause a
paper misfeed.
Set AD370 (duplex unit)
correctly.
Contact your sales or service
representative.
Contact your sales or service
representative.
Set the tray correctly.
Wait until the printer is warmed
up.
*1
*2
*3
Troubleshooting