Connecting The Printer Using The Network Interface Board 185 - Lanier 5222 Operator's Manual

Connecting the Printer Using the Network Interface Board 185

Connect the printer to the network using the Network Interface Board 185.
Follow these steps to connect the printer.
Introduction
1
Confirm that you have the correct cable.
2
Confirm that the machine is turned off.
3
Loop the network cable. The loop should be about 10cm (4") from the end of the cable on
the end closest to the printer.
4
Attach the ferrite core to the loop.
5
Attach the network cable to the 10BASE-T/100BASE-TX port on the machine.
•
Confirm that the cable is connected to the 10BASE-T/100BASE-TX port.
•
Do not connect the cable into the fax port.
6
Connect the other end of the cable into the network.
Connecting to the Printer
TAHX010E
1 - 3