Datamax M-class Mark II Operator's Manual page 12

5. Close the Printhead Assembly and press down until it locks into place.
6. Close the cover and press the
proper tracking.
If the printer does not correctly sense the top of each label, it may be necessary to calibrate the
printer. See section 3.5 Media Calibration.
The printer is factory set to use 4-inch media (and ribbon, if thermal transfer equipped). When using
a different width of media/ribbon, please refer to section 5.3.
6
button several times to position the media and ensure
FEED
Chapter 2 - Printer Setup
Printhead Assembly