View Control Roi - Bosch FLEXIDOME corner 9000 MP Software Manual

Camera Browser Interface
Pre-position
To move the camera to a pre-position, click one of the buttons
numbered one to six.
To store the current position of the camera in a pre-position:
1.
2.
3.
3.1.4

View Control ROI

(not for SD cameras)
When the stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated.
Refer to Section 9.2.1 H.264 settings, page 57 for more
information on setting up stream 2. (If dual ROI is available,
open the camera in a second browser window to set up the
second ROI on stream 2.)
Zoom
To zoom in on a region of the stream 2 image:


Select an area
To select a particular region of the image:
1.
2.
Bosch Security Systems
Position the camera.
Enter a pre-position number.
Click Set.
Click and hold
zoom out.
Click to see the full image.
Click and hold the arrows to move up and down, and from
side to side through the image.
Click and hold the center area to move in all directions.
Software manual
Operation via the browser | en
to zoom in; click and hold
AM18-Q0649 | v5.8 | 2013.06
17
to