Recording Track Selection; Standard Recording - Bosch FLEXIDOME corner 9000 MP Software Manual

66 en | Recording
10.2.1

Recording track selection

Standard and alarm recording can be defined for the two
recording tracks. You must first select the track before setting
up the standard and alarm recording parameters.
1.
2.
3.
4.
Recording includes
Specify whether, in addition to video data, audio or metadata
(for example alarms or VCA data) should also be recorded. (To
change the global audio format, click the audio recording
format link.)
Note:
Including metadata could make subsequent searches of
recordings easier but it requires additional memory capacity.
Without metadata, it is not possible to include video content
analysis in recordings.
10.2.2

Standard recording

Select the mode for standard recordings:
–
–
–
Stream
Select the stream to be used for standard recordings:
–
–
–
AM18-Q0649 | v5.8 | 2013.06
Click the Recording 1 entry in the list.
Set up the standard and alarm recording parameters for
track 1 as described below.
Click the Recording 2 entry in the list.
Set up the standard and alarm recording parameters for
track 2 as described below.
Continuous: the recording proceeds continuously. If the
maximum recording capacity is reached, older recordings
are overwritten automatically.
Pre-alarm: recording takes place in the pre-alarm time,
during the alarm and during the post-alarm time only.
Off: no automatic recording takes place.
Stream 1
Stream 2
I-frames only
Software manual
Camera Browser Interface
Bosch Security Systems