Configuring The Camera Before Installation; On-Site Commissioning; Setting The Field Of View; Wiring Of The Camera - Bosch AVIOTEC 8000i IR User Manual

26 en | Installation
–
–
–
–
4.2

Configuring the camera before installation

We recommend that you prepare the installation in the office, as you can carry out many
tasks here that are not recommended under time pressure and possibly on lifting platforms
etc.
We recommend that you carry out the following steps in advance:
1.
Unpack the camera and label it and the box with installation location and the later IP
address.
1.
2.
3.
4.
5.
6.
7.
4.3

On-site commissioning

1.
2.
3.
4.
4.4

Setting the field of view

After the camera is mounted to the surface, the field of view can be set. The camera lens
has a motorized automatic back focus to adjust the focus via the camera menu.
4.5

Wiring of the camera

Connection to Ethernet via PoE Ethernet cable
Notice!
i
Use only PoE approved devices.
The camera is intended to be powered via a STP Category 5e cable in a Power-over-Ethernet
(PoE) network environment (default power supply). Alternatively, a 12-26 VDC/24 VAC
power supply may be connected.
1.
2023.10 | 02 | F.01U.414.168
Download the latest firmware and tools (e.g. Configuration Manager)
IP address range change on Computer
A multimeter for testing the relay output
Analog monitor and cable for camera alignment
Labeling camera + cardboard
Use PoE to power the camera.
Start the Configuration Manager and change the IP address of the camera according to
the plan. You can perform steps 3 to 8 using the Configuration Manager.
Change the passwords for the users "service", "live", "user". If necessary, you can also
create additional users.
Check that the firmware version installed on the camera is up to date and update it if
necessary. Always test the fire detection after updating to the latest firmware.
Set the current time and date and assign a camera name if required.
Change the fire detection settings as planned.
Adjust the recording settings if necessary.
Install and align the camera at the planned installation site.
Adjust the opening angle as planned and focus the camera image by using the lens
wizard to fine-tune the focus.
Optional: If necessary, adjust the settings for fire detection to the conditions on site.
Document all settings and screenshots of the viewing area in the customer
documentation.
Connect the camera to a 10/100 Base-T network.
User manual
AVIOTEC 8000i IR
Bosch Sicherheitssysteme GmbH