CRANKCASE
CHECKING THE CRANKCASE
1.Thoroughly wash the case halves in a mild
solvent.
2.Clean all the gasket mating surfaces and
crankcase mating surfaces thoroughly.
3.Check:
Crankcase
G
Cracks/damage → Replace.
Oil delivery passages
G
Clogged → Blow out with compressed air.
CHECKING THE BEARINGS
1.Check:
Bearing
G
Clean and lubricate, then rotate the inner
race with a finger.
Roughness → Replace.
ASSEMBLING THE CRANKCASE
1.Apply:
Sealant (Quick Gasket
G
(to the mating surfaces of both case halves)
Sealant (Quick Gasket
P/N. ACC-11001-05-01
Yamaha bond No. 1215:
P/N. 90890-85505
2.Install:
Dowel pin 2
G
3.Fit the left crankcase onto the right case. Tap
lightly on the case with a soft hammer.
CAUTION:
Before
installing
crankcase holding bolts, be sure to check
whether the transmission is functioning
properly by manually rotating the shift cam
in both directions.
4 - 62
ENG
) 1
®
®
):
and
torquing
the