Installing The Universal Joint - Yamaha YFM45FAR Service Manual

FRONT CONSTANT VELOCITY JOINTS AND
DIFFERENTIAL GEAR
3.Install:
Universal joint yoke
G
O-ring
G
Washer
G
Nut
G
LT
Use a universal joint holder 1.
Universal joint holder:
P/N. YM-04062, 90890-04062
4.Check:
Differential gear operation
G
Unsmooth operation → Replace the
differential gear assembly.
Insert the double off-set joint into the
differential gear, and turn the gear back and
forth.

INSTALLING THE UNIVERSAL JOINT

1.Install:
Universal joint
G
*****************************************************
Installation steps:
G
Install the opposite yoke into the U-joint.
G
Apply wheel bearing grease to the bearings.
G Install the bearing 1 onto the yoke.
CAUTION:
Check each bearing. The needles can
easily fall out of their races. Slide the yoke
back and forth on the bearings; the yoke
will not go all the way onto a bearing if a
needle is out of place.
G
Press each bearing into the U-joint using a
suitable socket.
NOTE:
The bearing must be inserted far enough into
the U-joint so that the circlip can be installed.
G
Install the circlips 2 into the groove of each
bearing.
*****************************************************
7 - 13
DRIV
62 Nm (6.2 m • kg, 45 ft • lb)