Installing The Rear Axle Housing - Yamaha YFM45FAR Service Manual

REAR SHOCK ABSORBER AND SWINGARM

INSTALLING THE REAR AXLE HOUSING

1.Install:
Rear axle housing
G
Final gear case assembly
G
Rear axle
G
(with dust seal)
*****************************************************
Installation steps:
G
Install the drive shaft.
Refer to "REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT" in CHAPTER 7.
G
Apply sealant (Quick Gasket
surfaces of the swingarm and the final gear
case.
G
Temporarily install the rear axle housing 1
and final gear case assembly 2 on the
swingarm. The bolts and nuts 3 ~ 5 should
be temporarily tightened.
G Install the rear axle (with dust seal) 6 from
the left side of the machine.
Refer to "REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT" in CHAPTER 7.
G Tighten the bolts and nuts 3 ~ 5 in the
specified order.
3 Nut (×4)
4 Bolt (×4)
5 Bolt/nut (×4)
Nut 3:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
Bolt 4:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
Nut 5:
63 Nm (6.3 m • kg, 45 ft • lb)
*****************************************************
8 - 52
CHAS
®
) to the mating
®
®