FRONT AND REAR WHEELS
CHECKING THE WHEEL
1.Check:
Wheel
G
2.Measure:
Wheel runout
G
Over the specified limit → Replace the wheel
or check the wheel bearing play 1.
3.Check:
Wheel balance
G
Out of balance → Adjust.
WARNING
After replacing the tire, ride conservatively
to allow the tire to be properly seated in the
rim. Failure to do so may cause an accident
resulting in machine damage and possible
operator injury.
CHECKING THE WHEEL HUB
1.Check:
Wheel hub 1
G
Cracks/damage → Replace.
Splines (wheel hub) 2
G
Wear/damage → Replace.
8 - 3
CHAS
Wheel runout limit:
Radial 2: 2.0 mm (0.08 in)
Lateral 3: 2.0 mm (0.08 in)