Yamaha YFM45FAR Service Manual page 286

REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
3.Apply:
Sealant (Quick Gasket
G
(to the mating surfaces of the swingarm and
the final drive gear case)
Sealant (Quick gasket
P/N. ACC-11001-05-01
Yamaha bond No.1215:
P/N. 90890-85505
4.Install:
Final drive gear
G
Nuts
G
LT
Bolts
G
LT
5.Install:
Dust cover
G
Rear axle
G
*****************************************************
Installation steps:
G
Install the dust cover 1 onto the rear axle.
NOTE:
Adjust the length a to 210.1 mm (8.3 in) when
install the dust cover.
G Install the rear axle (with dust cover) 2.
G
Install the rear brake disc and rear wheel hub
(left).
G Temporarily tighten the left axle nut 3.
NOTE:
After tightening the rear axle nut 3, the
position of the dust cover 1 will slightly move
to protect the oil seal of the final gear case.
*****************************************************
7 - 31
DRIV
®
)
®
):
63 Nm (6.3 m • kg, 45 ft • lb)
63 Nm (6.3 m • kg, 45 ft • lb)