Where To Put The Machine - Kyocera FS-C1020MFP User Manual

Contents Previous
Top Page > Getting Started >

Where to Put the Machine

The machine's location should be carefully chosen because environmental conditions greatly affect its
performance.
●
●
●
●
●
●
●
●
●
●
●
●
Space Required for Installation
The recommended (minimum) space requirements are as follows:
Next
Installing the Machine > Where to Put the Machine
The supplied power cord is for use with this equipment only. Do not use with other appliances. Doing so
may result in fire, electric shock, or injury.
Keep the machine away from flammable liquids, gases, and aerosols. A fire or an electric shock might occur.
The wall outlet shall be installed near the machine and shall be easily accessible.
Connect the machine to the power source specified in this manual and do not use any other power sources.
Connect the power cord directly to a wall outlet and do not use an extension cord. Power sources not
specified in this manual and extension cords are electric shock or fire hazards.
Power cords that are damaged, broken, modified, trapped under heavy objects, pulled hard, or bent
severely are electric shock and fire hazards.
Touching the prongs of the power cable's plug with anything metallic constitutes a fire and electric shock
hazard.
Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies and small
children at all times. Suffocation can result if polythene materials are brought into contact with the mouth
or nose.
Keep the machine away from humidity and dust. Otherwise a fire or an electric shock might occur. Do not
place the machine on an unstable or tilted surface. If it topples over, an injury might occur.
Keep the machine in an area that is within optimum environmental conditions. Operating the machine in an
environment that is outside the recommended ranges of humidity and temperature can cause an electrical
fire hazard. Keep the area around the socket free of dust. Accumulated dust can become an electrical fire
hazard.
Make sure the room where you are using the machine is well ventilated and spacious. Good ventilation is
especially important when the machine is used heavily.
Machine is not suitable for desk work environments, so place the machine in another room.
When new, electrical devices containing volatile materials will normally release emissions into the air of their
vicinity. For this reason, for the first few days after installation of a new device, strong ventilation inside the
room where it is placed is necessary.
Settings