Scanner Problems - Kyocera FS-C1020MFP User Manual

Contents Previous
Top Page > Troubleshooting > Scanner Problems

Scanner Problems

This section describes scanner problems and possible solutions.
The machine does not start scanning.
The scanned image is dirty.
The scanned image is distorted or out
of position.
The scanned image is upside down.
The scanned image is blank.
The scanned image is too dark or too
light.
Top
Copyright © 2009
Next
Problem
Previous Next
The ADF or ADF cover is open. If the ADF or ADF cover is open, you
cannot scan using the ADF. Close the ADF or ADF cover.
The exposure glass or ADF is dirty. See
●
Before placing originals on the exposure glass, make sure that
●
toner or correction fluid is dry.
The original was moved during scanning. Do not move the original during
scanning.
The original was placed upside down. Place the original in the correct
orientation. See Placing Originals
The original was placed with the front and back reversed. When using the
exposure glass, place originals copy side down. When using the ADF,
place originals copy side up. See
Adjust the image density. See
Solution
Cleaning
.
Placing Originals .
Adjusting image density .
Settings
.