Adjusting Image Density - Kyocera FS-C1020MFP User Manual

Contents Previous
Top Page > Using the Copier Function

Adjusting Image Density

This section describes how to adjust image density for the current job.
There are five image density levels. The higher the density level, the darker the printout.
Press the [Density] key.
Press the [Density] key or [ ][ ] keys to select the desired density level, and then press
the [OK] key.
Press the [
●
You can change the machine's default [Density] setting to always make copies with a specific density level.
●
Temporary job settings are cleared in the following cases:
●
For details about [Density], see
●
For details about [Auto Clear], see
●
Top
Copyright © 2009
Next
> Specifying Scan Settings
] key or [Clear/Stop] key to discard the current change and return to the initial screen.
When no input is received for the period of time specified in [Auto Clear] while the initial screen is displayed.
When the [Clear/Stop] key is pressed while the initial screen is displayed.
When the machine's mode is changed.
When the power is turned off.
When the machine's default for the same setting is changed.
Previous Next
> Adjusting Image Density
Copy Settings .
Administrator Settings .
Settings