KVH Industries antenna system User Manual page 87

TracVision Receiver User's Guide
Receiver Locked Up
Since your receiver is a computing component, it is
susceptible to erratic changes in power and/or signal,
like any other computer, and these sudden changes
can cause it to become "confused." To clear this
condition, try pressing the remote control's SAT
button before trying to control the receiver. If that
doesn't work, press the SAT and MUTE buttons
together and try again.
If that doesn't work,
turn off vehicle/vessel
power or the receiver's
rear panel power
switch for 30 seconds,
then turn it back on.
RF Converter Too Close to Receiver
The RF converter must be placed at least three feet
away from the receiver. Placing the RF converter
closer to the receiver may result in interference,
causing the remote control to operate intermittently
or not at all.
9.8
Power Switch
CAUTION
VHF ANTENNA
IN
VEHICLE POWER
(10-16 VDC)
POWER
RF
REMOTE
OUT TO TV
SATELLITE IN INPUT
TUNER AUDIO R AUDIO L
Remote Control Batteries Dead
To replace the remote control's batteries, follow the
steps below.
1. Remove the battery compartment cover on the
back of the remote control.
2. Insert two AAA batteries as shown, observing the
correct polarity.
3. Replace the battery compartment cover.
VIDEO
Remote Control Batteries
If you lose your remote control, please call
or visit your local KVH authorized dealer to
order a replacement.
54-0287