Center Binding; Hole Punching - Konica Minolta BIZHUB C250P User Manual

Specifying printer driver settings

Center Binding

You can specify to center staple and fold a printed document.
1
Click the Layout tab.
2
From the "Center Staple and Fold" drop-down list, select "Center Sta-
ple and Fold".
3
To avoid printing on the folded part of the document, select the "Center
Erase" check box.
Note
"Center Staple and Fold" cannot be specified if "Staple" or "Punch" has
been selected.
"Center Staple and Fold" is available if optional finisher FS-603 or if sad-
dle stitcher SD-503 is installed on optional finisher FS-514 is installed.
"Center Erase" is available only if finisher FS-603 is installed.
The available center binding and folding settings differ depending on the
finisher that is installed. When FS-514 is installed, in addition to "Fold &
Staple" (which folds the documents in half before stapling them), "Center
Staple" (which binds documents with staples at the center) and "Fold"
(which folds documents in half) are available. When FS-603 is installed,
only "Center Staple and Fold" is available.

Hole punching

Holes can be punched into the printed document.
1
Click the Layout tab.
2
From the drop-down list, select whether two or three holes are to be
punched.
Note
The hole punch function is available only when optional finisher FS-603
and punch kit PK-501 are installed or when optional finisher FS-514 and
punch kit PK-510 are installed.
C250P
3
3-56