3
3.8
Manual transmission
Manual transmission
This operation is performed when sending documents and confirming the
status of the receiving machine.
Memory transmission cannot be used with manual transmission.
1
Press [Fax] on the control panel to display the fax screen.
2
Place the original.
–
For details, refer to "Placing the original on the machine" on
page 3-7.
3
Press [Off-Hook].
–
If [RX] has been selected, press [TX] to switch to the transmission
mode.
4
Set the functions of scan setting as necessary.
–
See "Setting transmission conditions" on page 3-11 for setting
functions on the fax screen.
–
See "Application functions overview" on page 7-5 for setting func-
tions on the fax application screen.
5
Select the destination with the keypad.
–
You can input up to 60 digits.
–
Pressing [On-Hook] returns the display to the fax screen.
–
When an external telephone is connected, documents can be sent
by lifting up the receiver of the external telephone.
6
When the signal sounds, press [Start] of the off-hook screen.
–
Pressing [Start] on the control panel allows the off-hook start fax
communication screen confirmation to appear. Transmission starts
when you press [Yes].
–
When the external telephone is connected, hang up the receiver of
the external telephone after pressing [Start].
Transmission begins.
3-34
Transmission
C450