Konica Minolta bizhub C450 Fax Manual page 148

7
Function
Frame erase:
Background adjustment:
Sharpness:
Number of originals:
Scan size:
File type:
Quick memory TX:
Password TX
Polling TX:
Polling RX:
Timer TX:
*2
F-code TX
Line setting
*1 :
This can be used to transmit to receiving stations with closed area communication mode
selected.
It is impossible to communicate with a fax without F-code function.
*2
:
F-code is used.
7-6
Description
When transmitting pages in a book, this function allows you to
erase dark bands that would otherwise be reproduced in the
marginal areas of the transmitted pages. (page 7-13)
Function to send a message after adjusting the density in the
background color of the original. (page 7-16)
Function to send a message after making the edge of character
sharpened. (page 7-19)
In quick memory transmission, the total number of pages trans-
mitted can be included in the page number information.
(page 3-44)
This function allows you to designate the size of the document
to be transmitted. It is convenient when you intend to transmit
part of a page or pages. (page 7-22)
Specify the format of an attached file when sending a message
by e-mail. (page 7-25)
Function to send a message each time a page of document is
read. (page 3-42)
*1
: Transmission can be sent with a password attached, as re-
quired when the receiving station is using a closed area com-
munication mode. (page 7-27)
This function allows you to read a document and store it in
memory until the destination initiates transmission by sending a
command to receive (polling). (page 9-3)
This function allows you to initiate reception by sending a com-
mand to a destination to receive a document that is set for
transmission at the destination. (page 9-6)
The time to start communication can be specified. (page 3-47)
: This is a function in which the SUB address and the password
are specified to use the Confidential Communication, the relay
request, and the bulletin board. (page 7-27, page 7-30,
page 7-35, page 9-9)
Overseas TX A lower baud rate will be employed. (page 3-50)
ECM OFF Error correction mode (ECM) can be disabled. (page 7-38)
V.34 OFF When the V.34 protocol can not be used due to restrictions of
exchange equipment, the V.34 mode is disabled for transmis-
sion. (page 7-41)
Transmission applications
C450