Konica Minolta bizhub C450 Fax Manual page 126

4
!
Detail
If the size of the paper on which the facsimile actually prints is smaller
than that of the paper selected at step 1, the document is printed in re-
duced size.
If the direction of the paper on which the facsimile actually prints is dif-
ferent with that of the paper selected at step 1, the document is automat-
ically printed so that it can be output appropriately rotated by a 90-
degree angle.
If you print mixed size documents, this process is executed on each
page.
If the paper sizes selected in step 1 and step 2 are set in several paper
trays, the paper tray used is selected according to the setting of the au-
tomatic paper size selection function. Refer to the "User's guide – Copy
operations" for more detailed information.
If the required paper size is only set in the manual insertion tray, the doc-
ument is printed on the paper fed from the tray; however, if the automatic
paper size selection function or the automatic tray selection function is
disabled on the tray, the tray is not selected.
Even if the page division is set to ON, the page will not be divided if the
[TX/RX Setting] is set as follows.
[Tray Selection for RX Print]]is set
[Duplex Print (RX)] is set to ON
If no printable paper is set, a message asking you to set the printable pa-
per appears.
If [Print Paper Selection] is set to [Priority Size]:
The appropriate paper is selected among 8.5 × 11, 8.5 × 14 and 11 × 17
(A4, B4 and A3). If it is not available, it is recorded after being reduced to
fit in closest size of paper.
If [Print Paper Selection] is set to [Fixed Size]:
The appropriate paper is selected among 8.5 × 11, 8.5 × 14 and 11 × 17
(A4, B4 and A3). If it is not available, the message stays appearing until
the paper is loaded.
4-14
Reception
C450