Adjusting The Pitch Of The Two Staples - Konica Minolta bizhub 750 Copy Manual

12
– If the folding position is too far on the left side of the paper, touch
[–] (between –0.1 mm and –12.8 mm).
12
Repeat steps 6 through 11 until the desired print results are achieved.
13
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm

Adjusting the Pitch of the Two Staples

The distance between the two staples can be adjusted.
0 Use the "2 Position" Staple function to print a single sample copy, and
then perform the adjustment while checking the sample that was created.
0 [6 2 Position Staple] appears only if finisher FS-602 is installed.
1
Display the Administrator Setting screen.
2
Touch [1 System Setting].
The System Setting screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
12-68
Utility
bizhub 750/600