Konica Minolta bizhub 750 Copy Manual page 223

5
Symptom
There are dark specks or
spots throughout the
printed output.
There are streaks in the
printed output.
The image is not aligned
properly on the paper.
The printed page is
curled.
5-12
Possible Cause
Is the original glass dirty?
Is the left partition glass dirty?
Is the ADF platen guide cover
dirty?
Was the original document
printed on highly translucent
material, such as trace paper
or overhead projector trans-
parencies?
Is a double-sided document
being copied?
Is the document incorrectly
positioned?
Is the document incorrectly
positioned in the ADF?
Is the original glass dirty
(while using the ADF)?
Are the adjustable document
guides incorrectly positioned
against the edges of the doc-
ument?
Was curled paper loaded into
the paper tray?
Was paper that curls easily
(as with recycled paper)
used?
Troubleshooting
Remedy
Wipe the glass with a soft, dry cloth.
(See p. 10-3.)
Wipe the glass with a soft, dry cloth.
(See p. 10-3.)
Wipe the ADF platen guide cover
with a soft, dry cloth. (See p. 10-4)
Place a blank sheet of paper on top
of the document. (See p. 3-9.)
If a thin double-sided document is
being copied, the information on the
back side may be reproduced in the
copy. Touch [Lighter] on the Back-
ground Removal screen to select a
lighter background density. (See
p. 3-49.)
Correctly position the document
against the document scales. (See
p. 3-9.)
Load the document into the ADF,
and slide the adjustable document
guides to fit the size of the docu-
ment. (See p. 3-7.)
If the document cannot be fed cor-
rectly through the ADF, make cop-
ies by positioning the document on
the original glass. (See p. 3-9.)
Wipe the glass with a soft, dry cloth.
(See p. 10-3.)
Slide the document guides against
the edges of the document.
Flatten the paper before loading it.
Remove the paper from the paper
tray, turn it over, and then load it
again.
Replace the paper with paper that is
not damp.
bizhub 750/600