Konica Minolta bizhub 750 Copy Manual page 467

User’s guide [copy operations]

Hide thumbs Also See for bizhub 750:

Table of Contents

If the punch positions are too far on the left side of the paper, touch

[–] (between –0.1 mm and –5.0 mm).

Repeat steps 7 through 11 until the desired print results are achieved.

To cancel changes to the settings, touch [Cancel].

Enter the value by mm using the keypad. Refer to the conversion rate be-

low. 1 in. = 25.4 mm

When PK-505 and ZU-602 are installed, adjustments can be made using

both the "Punch Adjustment" and "Z-Fold Position Adjustment" param-

eters. Contact your technical representative.

bizhub 750/600

Troubleshooting