Receiving Data From Personal Computer - Furuno GP-150 Installation Manual

Marine gps navigator
Hide thumbs Also See for GP-150:
Table of Contents

Advertisement

8. MENU SETTINGS
Setting DATA 4 to NMEA
The DATA 4 port connects to a personal
computer, DGPS receiver or YEOMAN
equipment.
1) Press MENU ESC, 9 and 5. The DATA 4
I/O SETUP (1/2) menu appears.
DATA 4 I/O SETUP
DATA 4. Level
RS232C
Data
Out
To Next Page
: Select
ENT : Enter
Appears only when external
DGPS receiver is used.
Figure 8-10 DATA 4 I/O SETUP menu (1/2)
2) Press
or
to select Level.
3) Press
or
to select level of external
equipment; RS232C or RS422.
4) Press the NU/CU ENT key.
5) Press
or
to select Out.
6) Press
to select To Next Page. The
DATA 4 I/O SETUP (2/2) menu appears.
DATA 4 I/O SETUP
To Previous Page
Data Fmt.
V1.5
Talker ID
GP
Output Data
(00-90 sec)
1. AAM:00
APA:00
2. BWR:00 BWW:00 GGA:00 GLL:01
3. RMB:01 RMC:00 VTG:01
4. VDR:00 WPL:00 XTE:00
5. GNS:00 GBS:01 Rnn:00
ENT : Enter
Figure 8-11 DATA 4 I/O SETUP menu (2/2)
7) Follow "DATA 1 output setting" from step
2.
8-8
1/2
RS422
Com. DGPS
MENU : Escape
<Out>
2/2
V2.0
IEC
LC
DE
98%
APB:04
BOD:00
WCV:00
ZDA:01
RTE:00
MENU : Escape
8.5
Receiving Data from
Personal Computer
Loading Waypoints/Routes data
Waypoints and Routes data can be
downloaded from a personal computer,
through the DATA 4 connector.
1) Press MENU ESC, 9 and 5.
2) Press
or
to select Level.
3) Press
or
to select level of personal
computer; RS232C or RS422.
4) Press the NU/CU ENT key.
5) Press
to select Com.
6) Press
to select To Next Page. The
DATA 4 I/O SETUP menu appears.
DATA 4 I/O SETUP <Com.>
To Previous Page
Baud Rate
9600 bps
Load Data
WPT/RTE
Command
Stop
Save Data
WPT/RTE
Command
Stop
: Select
ENT : Enter
Figure 8-12 DATA 4 I/O SETUP menu (2/2)
7) Press
or
to select Baud Rate.
8) Press
or
to select baud rate;
4800bps, 9600bps, or 19200bps.
9) Press the NU/CU ENT key.
10) Press
to select WPT/RTE.
11) Press
to select Command. Stop, on
the same line as Command, appears in
reverse video.
12) Press
to select Start. The message
shown in Figure 8-13 appears.
Loading erases current data
and stops Route navigation
Are you sure to load ?
ENT: Yes
MENU:No
Figure 8-13
2/2
WPT
Start
Start
MENU : Escape

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents