Furuno GP-150 Installation Manual page 29

Setting DATA 4 to "COM." (general data)
Waypoints and Routes data can be received from a personal computer, through the DATA
4 port.
1) Press MENU ESC, 9 and 5.
2) Press or to select DATA4. Level.
3) Press or to select level of personal computer; RS232C or RS422.
4) Press the NU/CU ENT key.
5) Press to select Com.
6) Press to select To Next Page. The DATA 4 I/O SETUP <Com.> menu appears.
7) Press or to select Baud Rate.
8) Press or to select baud rate; 4800bps, 9600bps or 19200bps.
9) Press the NU/CU ENT key.
10) Press or to select WPT/RTE.
11) Press to select Command. Stop, on the same line as Command, appears in reverse
video.
12) Press to select Start. The message shown in figure below appears.
13) Press the NU/CU ENT key. The message shown in below appears while data is being
loaded.
DATA 4 I/O SETUP <Com.> 2/2
To Previous Page
Baud Rate 9600 bps
L WPT/RTE
Load Data
Command Stop
Save Data WPT/RTE
Command Stop
: Select
ENT : Enter
MENU : Escape
DATA 4 I/O SETUP <Com.> menu
Loading erases current data
and stops Route navigation
Are you sure to load?
ENT: Yes MENU: No
Now loading
Waypoint/Route data !
MENU: Stop
21
WPT
Start
Start
6. INITIAL SETTINGS