Water Temperature Alarm; Depth Alarm; Dgps Alarm - Furuno GP-150 Installation Manual

7. ALARMS
7.5 Water Temperature
Alarm
The water temperature alarm sounds when
the water temperature is higher or lower (or
within) the preset temperature. This alarm
requires temperature signal from external
equipment.
1) Press MENU ESC and 4.
2) Press or to select Water Temp.
3) Press or to select In (or Over).
4) Press to select Temp. Range.
5) Key in low temperature.
6) Key in high temperature.
7) Press the NU/CU ENT key.
8) Press the MENU ESC key.
When the water temperature is higher or
lower (or within) the preset value, the buzzer
sounds and the message "Water temp
alarm" appears. You can silence the audible
alarm by pressing the CLEAR key. To erase
the visual alarm, press the CLEAR key
again.
To disable the alarm, select Off at step 3.
7-4
7.6

Depth Alarm

The depth temperature alarm sounds when
the depth is higher or lower (or within) the
preset depth. This alarm requires video
sounder connection.
1) Press MENU ESC and 4.
2) Press or to select Depth.
3) Press or to select In (or Over).
4) Press to select Depth Range.
5) Key in low depth.
6) Key in high depth.
7) Press the NU/CU ENT key.
8) Press the MENU ESC key.
When the depth is higher or lower (or within)
the preset value, the buzzer sounds and the
message "Depth alarm" appears. You can
silence the audible alarm by pressing the
CLEAR key. To erase the visual alarm, press
the CLEAR key again.
To disable the alarm, select Off at step 3.
7.7 WAAS/DGPS Alarm
The WAAS/DGPS alarm sounds when the
WAAS/DGPS signal is lost. This alarm may
be enabled or disabled as below.
1) Press MENU ESC and 4.
2) Press or to select WAAS/DGPS.
3) Press to select On, or
4) Press the NU/CU/ENT key.
5) Press the MENU ESC key.
to select off.